2) Press the <ENTER> button.
f
The
[PROJECTOR NAME CHANGE]
screen is displayed.
3) Select characters with the
asqw
buttons and press the <ENTER> button to enter the projector
name.
f
You can enter up to eight characters.
4) After entering the projector name, press
as
to select [OK] and press the <ENTER> button.
Note
f
The factory default setting of the projector name is “Namexxxx”. xxxx is a fixed value assigned to each projector.
[NETWORK CONTROL]
Set up the control method of the network.
1) Press
as
to select [NETWORK CONTROL].
2) Press the <ENTER> button.
f
The
[NETWORK CONTROL]
screen is displayed.
3) Press
as
to select an item and press
qw
to change the setting.
[WEB CONTROL]
Set to [ON] to control with the web browser.
[PJLink CONTROL]
Set to [ON] to control with the PJLink protocol.
[PJLink NOTIFICATION]
Set to [ON] to use the PJLink notification function.
f
The [PJLink NOTIFICATION] screen is displayed when set to [ON] and the <ENTER> button is
pressed. Set the IP address of the computer to notify the status of the projector in [NOTIFIED IP
ADDRESS 1], [NOTIFIED IP ADDRESS 2].
[COMMAND CONTROL]
Set to [ON] to control with the <SERIAL IN> terminal control command format (
x
page 138). Refer
to “Control commands via LAN” (
x
page 135).
[COMMAND PORT]
Set the port number used for command control.
[Crestron Connected(TM)]
Set to [ON] to control with Crestron Connected of Crestron Electronics, Inc.
[AMX D. D.]
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, visit the
website of AMX Corporation.
URL http://www.amx.com/
[EXTRON XTP]
Set to [ON] when connecting the “XTP transmitter” of Extron Electronics to the <DIGITAL LINK/LAN>
terminal.
The [EXTRON XTP] setting must be set to [OFF] when connecting the optional DIGITAL LINK output
supported device (Model No.: ET-YFB100G, ET-YFB200G).
For details of the “XTP transmitter”, visit the website of Extron Electronics.
URL http://www.extron.com/
4) Press
as
to select [OK] and press the <ENTER> button.
[MEMORY VIEWER]
Set the operations of the Memory Viewer function.
Note
f
The [MEMORY VIEWER] menu can be operated and set only when MEMORY VIEWER input is selected.
f
For details on how to use the memory viewer function, please refer to “Projecting with MEMORY VIEWER input” (
x
page 101).
[SET SLIDE]
Start the slideshow. For details on the slideshow, see “Executing the slide” (
x
page 102).
[SLIDE TRANSITION EFFECT]
Sets the transition effects when switching the slides playback.
1) Press
as
to select [SLIDE TRANSITION EFFECT].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[SLIDE RIGHT]
The slides switch from left to right.
ENGLISH
-
97
Chapter 4 Settings - [NETWORK] menu
