1) Press
as
to select the [SCREEN FORMAT].
2) Press
qw
to select the aspect ratio.
3) Press
as
to select the [SCREEN POSITION].
f
When [SCREEN FORMAT] is set to [16:10], the
[
SCREEN POSITION]
cannot be changed.
f
When [SCREEN FORMAT] is set to [16:9] or [4:3], proceeds to Step
4)
.
4) Press
qw
to select the image position.
f
Select from [CENTER]/[HIGH]/[LOW] or [CENTER]/[LEFT]/[RIGHT].
Setting [STANDBY MODE]
Set the operating mode at standby. When the initial setting is complete, you can change the setting from the
[PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE].
1) Press
as
to select [STANDBY MODE].
2) Press
qw
to select the operation mode.
f
The factory default setting is [NORMAL], which enables the network function even in standby mode.
f
To lower the power consumption level during standby, set to [ECO].
Making adjustments and selections
It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
6)
3)
5)
5)
1)8)
4)
4)
4)
7)
7)
1) Roughly adjust the focus of the image with the focus lever. (
x
page 50)
2)
Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (
x
page 32)
f
Refer to “Navigating through the menu” (
x
page 59) for the operation of the menu screen.
3) Press the input selection buttons on the remote control or the <INPUT SELECT> button on the control
panel to select the input signal.
f
The buttons that can be used on the remote control are as follows.
<HDMI 1> button, <HDMI 2> button, <DIGITAL LINK> button, <COMPUTER 1/2> button, <VIDEO> button,
<NETWORK/USB> button
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (
x
page 50)
5) Adjust the horizontal / vertical projection position with the horizontal / vertical lens shift dial.
(
x
page 50)
6) Adjust the size of the image to match the screen with the zoom lever. (
x
page 50)
7) If the input signal is an analog RGB signal, press the <AUTO SETUP> button.
8) Adjust the focus again with the focus lever.
Note
f
When the projector is switched on for the first time after purchase or the [PROJECTOR SETUP] menu
→
[INITIALIZE ALL] is executed, the
[INITIAL SETTING]
screen is displayed after projection starts. Refer to “When the initial setting screen is displayed” (
x
page 44).
46 -
ENGLISH
Chapter 3 Basic Operations - Switching on/off the projector
