Chapter 3
Basic Operations — Switching on/off the projector
ENGLISH - 61
f
To set the projector based on luminance
Luminance (lm)
When [CONSTANT MODE] is set to [OFF]
When [CONSTANT MODE] is set to [AUTO] or [PC]
[MAX LIGHT
OUTPUT LEVEL]
(%)
[LIGHT OUTPUT]
(%)
Runtime (hour)
[MAX LIGHT
OUTPUT LEVEL]
(%)
[LIGHT OUTPUT]
(%)
Runtime (hour)
6 000
100.0
100.0
20 000
―
―
―
5 500
100.0
92.0
22 000
100.0
―
―
5 000
100.0
83.0
24 000
100.0
83.0
4 000
4 500
100.0
75.0
26 000
100.0
75.0
7 000
4 000
100.0
67.0
28 000
100.0
67.0
11 000
3 500
100.0
58.0
29 500
100.0
58.0
16 000
3 000
100.0
50.0
31 500
100.0
50.0
22 500
2 500
100.0
42.0
33 500
100.0
42.0
30 000
2 000
100.0
33.0
35 000
100.0
33.0
39 000
Note
f
The runtime may be shorter than the estimation due to the influence of characteristics of each light source, conditions of use, installation
environment, etc.
f
The duration of use is referred to as the runtime when you use the projector successively. The duration of use is an estimated duration and
is not the warranty period.
f
If the runtime exceeds 20 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
Initial setting (installation setting)
Set [FRONT/REAR] and [FLOOR/CEILING] in [PROJECTION METHOD] depending on the installation mode.
Refer to “Installation mode” (
x
page 32) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu
→
[PROJECTION METHOD].
1) Press
qw
to switch the setting.
3/7
ENTER
SET
CHANGE
Change the projection method (FRONT/REAR,
FLOOR/CEILING) if the screen display is upside down
or inverted.
PROJECTION METHOD
INITIAL SETTING
FRONT/REAR
FLOOR/CEILING
MENU SELECT
FRONT
AUTO
2) Press the <ENTER> button to proceed to the initial setting.