11
2. Web Browser-based Control
The Web browser-based control function (hereinafter called the Web control func
-
tion) allows you to easily perform administration tasks, such as configuration and
monitoring, from a web browser, Microsoft Internet Explorer.
The Web control function allows you to configure and monitor this switch over the
network via the user interface of your Web browser. You can also control this
switch from a remote location as if it is at your fingertips because statuses can be
displayed.
2.1.
System Requirements
You need to configure the network settings before using the Web control function
of this switch.
1. Configuring the System IP Address
Using the console, configure the IP address of this switch.
Select "Basic Switch Configuration..." > "System IP Configuration" > "Set IP
Address" to configure the IP address. Then, select "Set Subnet Mask" to config
-
ure the subnet mask. If required, select "Set Default Gateway" to configure the
default gateway address.
2. Enabling the Web Control Function
Enable the Web control function of this switch.
From the main menu, select "Basic Switch Configuration..." > "System Security
Configuration" > "Web Server Status" and the command prompt changes to
"Enable or Disable web server (E/D) ." Enter "e" to enable the Web control func
-
tion. "Disable" is the factory default setting.
The terminal to be accessed should have Microsoft Internet Explorer 11.0 installed.
Also, the terminal needs to directly connect to a network or this switch.
Note:
The active window may not be correctly displayed if you use a proxy. Direct
access without a proxy is recommended.
