Panasonic PanaXSeries MN1030 Series, User Manual

Page: 73 / 340

Chapter 5 Using Assembler
Starting Assembler 61
5.2 Starting Assembler
The assembler is started by entering the command name and the desired parameters. The command
name differs depending on the device being used. This chapter uses the terminology of as103 as its
general format.
General format of commands
Below is the general format of the command to use when starting the assembler.
as103 [options] source_filename
Contents of brackets [ ] may be omitted.
Specifying options
An option starts with a hyphen (-) as the options specifier, followed by a character that indicate the
particular option.
-l
Option specifications are case sensitive, so upper case and lower case letters must be specified
correctly.
-Lc
Single-character options not accompanied by parameters can be specified as multiple characters
following the hyphen (-) option specifier. The order is optional.
-gl
When an option is accompanied by a parameter and other options are to follow, add a space after the
parameter, and follow with the hyphen (-) option specifier.
-I/user/source -Li -Lc
Parameters can be specified right after the option character or separated by one space.
-I/user/source or -I /user/source
When options are omitted, assembly will be perform in accordance with the default interpretations built
in to the assembler. Refer to section 5.3, "Command Options", for default interpretations.
NOTE: Omitting the path specifies that the source file is in the current directory.
Specifying a path for the source file does not affect the listing file and relocatable
object file. They are always created in the current directory. Note, however, that
the -o option is available for creating the relocatable object file in another
directory.