Panasonic Panafax UF-5300, Service Manual

Page: 136 / 274

136
Function Parameter Table
No. Parameter Selections Function
000 MON/TEL DIAL 1 = Monitor
2 = TEL/DIAL
Selects whether the machine starts to TX
automatically during On-Hook dialing.
Monitor : Start to TX after pressing START
TEL/DIAL : Start to TX automatically
001 ALARM
STATUS
1 = OFF
2 = Timer (6 sec.)
3 = Constant Selects the No Paper or No Toner alarm status.
OFF : Alarm is disabled.
Timer : Alarm will shut off after 6 seconds.
Constant : Alarm will not stop until "STOP" is
pressed or the error is cleared/corrected.
002 STOP COMM.
JRNL
1 = Off
2 = On Selects whether the machine prompts to print the
COMM. Journal when the printout condition is set to
INC and STOP is pressed during communication.
003 CONTINUOUS
POLL
1 = Off
2 = Stn (Tx only) Selects whether the Continuous Polling feature is
enabled.
Stn :
Place the document(s) on the ADF then press the
Program Key [P4] to store or add the document(s)
into a polled file. (See Note 4)
004 NUMERIC ID
SET
1 = Off (will not accept)
2 = On (accepts) Selects whether the machine accepts and allows to
set or change the Numeric ID.
005 Not Used
006
ID DISPLAY 1 = Number (Numeric ID)
2 = Chara (Character ID)
3 = Name (Station Name)
4 = Dial (Dialing Number)
Selects the priority of displaying/Printing the ID,
Name or Dialing Number. (Default : 3 = Name)
1 = Number: Number>Name>Chara>Dial
2 = Chara : Chara>Name>Number>Dial
3 = Name : Name>Chara>Number>Dial
4 = Dial
: Dial>Name>Chara>Number
007 Not Used
008 MONITOR 1 = Off
2 = On Selects whether the Monitor is ON/OFF for
monitoring fax signals.
(FOR SERVICE USE ONLY)
009 DC LOOP 1 = Off (Normal)
2 = On (Off Hook) Selects a false Off Hook state for back to back
communication test.
010 TX LEVEL 00 = 0 dBm
~
15 = -15 dBm Selects the TX signal output level, 0 to -15 dBm in 1
dBm steps. (Refer to Chapter 4.3.)
011 RX LEVEL 1 = -43 dBm
2 = -38 dBm
3 = -33 dBm
4 = -48 dBm Selects the receiving sensitivity of -33/-38/-43/-48
dBm.
012 DTMF LEVEL 00 = 0 dBm
~
15 = -15 dBm Selects the DTMF output level, 0 to -15 dBm in 1
dBm steps.
013 G3 RX EQL 1 = 0 dB
2 = 4 dB
3 = 8 dB
4 = 12 dB Selects the cable equalizer for G3 reception mode,
0dB, 4dB, 8dB or 12dB.
014 G3 TX EQL 1 = 0 dB
2 = 4 dB
3 = 8 dB
4 = 12 dB Selects the cable equalizer for G3 transmission
mode, 0dB, 4dB, 8dB or 12dB.