Receiving Documents
60
TAM (Telephone Answering Machine) Interface Mode
Setting the TAM Interface Mode
Operation of TAM Interface Mode
1
Change Fax Parameter No. 16 (OUT MODE) to 2: TAM / Fax
(See page 33)
2
Make sure that the lamp goes on.
RCV MODE=TAM/FAX
If it is a Fax call,
1
When your TAM and Fax receives an incoming call, the
TAM always answers the call first and then the TAM plays
the OGM (Outgoing Message) recorded in your TAM to
the calling station. During the time the TAM is answering
the call, your fax machine will be monitoring the line to
distinguish whether it is a voice or fax call.
2
Your machine will switch the line to the fax and then begin
to receive the documents immediately from the calling
station.
If it is a Voice call,
1
When your TAM and Fax receives an incoming call, the
TAM always answers the call first and then the TAM plays
the OGM (Outgoing Message) recorded in your TAM to
the calling station. During the time the TAM is answering
the call, your fax machine will be monitoring the line to
distinguish whether it is a voice or fax call.
2
Your TAM continues to record the incoming message
(ICM) after playing the OGM.
Sample of OGM
Hello, this is Smith. Sorry I am unable to take your call. Please leave your message after the beep or if
you are calling to send a fax, press the asterisk button twice on your touch tone phone now and start
your machine. Thank you for calling.
Silent Detection Mode
Enables your Fax machine to switch to the Fax Mode when receiving from units that do not send fax
signal (short beep) and prevents your TAM from recording blank (long silence) incoming message.
To activate this feature,
1.
Change Fax Parameter No. 20 (SILENT DET.) to 2: Valid.
2.
Set the time length of the OGM recorded in your TAM with the Fax Parameter No. 19 (OGM
LENGTH).
[We recommend to set the time length 5 or 6 seconds longer than the actual time length of the OGM.]
