Troubleshooting
4
Camera Setup Difficulties
Note
If you are experiencing any problems, it is recommended that you
temporarily disable all firewall, pop-up killer, and virus detection
software. Once the problem is identified and corrected, you can restart
the Setup Program.
Indicator does
not light up.
• Indicator display is disabled.
Check if the indicator control is disabled (see page 133 of the
Operating Instructions on the Setup CD-ROM).
• Confirm that the standard AC adaptor PQLV202 (Order No.
PQLV202Y) is being used.
Indicator
continues
blinking red.
• The camera may be malfunctioning.
If you cannot access the camera, the camera may be
malfunctioning. Call our customer call center.
Problem
Cause and Remedy
Automatic Setup
fails using Setup
Program.
• More than 20 minutes have passed, after turning the camera
on.
Disconnect the plug of the AC cord from the outlet, and
reconnect it again. Set up the camera again.
• Multiple camera IP addresses are overlapping.
If you install multiple cameras, turn the camera on one by
one.
• A problem occurs during the setup.
After confirming that the network is active, disconnect the
plug of the AC cord from the outlet, and reconnect it again.
And set up the camera again.
Viewnetcam.com
registration fails
using Setup
Program.
• If you do not receive an E-mail from the Viewnetcam.com
service, your registered E-mail address may be incorrect.
Register your correct E-mail address again at the
Viewnetcam.com website at
http://www.viewnetcam.com
.
Problem
Cause and Remedy
