38
510549
Problem/error
Cause
What to do ...?
The dryer does not work.
• No voltage from the mains
socket.
• Check if the mains plug is
correctly inserted into the mains
socket.
• Check the fuse.
There is voltage at the
mains socket, but the
drum does not spin and
the dryer does not work.
• Programme was not started
in accordance with the
instructions.
• The door is not properly
closed.
• Water container is full.
• Delayed start function has
been selected.
• Reread the instructions for use
again.
• Push the door towards the
appliance.
• Empty the water container
(see section Cleaning and
Maintenance).
• Wait until the time indicated on
the display elapses.
Laundry is not dried, or
drying time is longer
than 4h.
• Filters are not clean. The
room is not sufficiently
ventilated.
• Inappropriate temperature
in the room.
• Laundry was not sufficiently
wrung or spun.
• Amount of laundry dried in
the appliance is too large or
insufficient.
• Clean the filters.
• Install the dryer in an
appropriate room (see section
Installation ...)
• Check if the temperature in
the room where the dryer is
installed is too high (over 25 °C)
or too low (below 10 °C).
• Laundry inserted into the dryer
was not sufficiently wrung or
spun, or an inappropriate drying
programme was selected.
• Use an appropriate programme
or use the timed programme.
Increase the final level of
dryness for the selected
programme (intensive drying
function).
Unevenly dried laundry.
• The amount of laundry
dried at a time is too large.
• Drying the pieces of
different thicknesses.
• Drying the different types
of laundry.
• Make sure the laundry is sorted
by type and size of items given
the selected programme (see
section Drying – Preparing the
Laundry and the Programme
Table).
Error in the drum
lighting.
• The light does not turn
on when the dryer door is
opened.
• Disconnect the dryer from mains
power and call an authorised
service centre.
On display: F3
• Full water container.
• If the water container is
empty, there is a pump
failure.
• Empty the water container
(see section Cleaning and
Maintenance).
• Disconnect the appliance and
call an authorised service centre.
On display: F4
• Clogged filters.
• If the filters are clean,
there may be a compressor
failure.
• Clean the filters.
• Disconnect the appliance and
call an authorised service centre.
Write down the failure/error code:
F0, F1, or F2,
disconnect the appliance and call the
nearest authorised service centre.
NH-P8ER1_WGB_En.indd 38
2015/08/24 10:55:58
