Troubleshooting
17
Troubleshooting
Symptoms
Points to be checked
Time
Time indication increases or
does not change.
● Time indication is approximate. Remaining time is corrected
during operation and displayed.
Operation time is longer than
the time indication.
Operation does not stop even
after the reservation time.
●
The operation time may be longer if laundry is concentrated on
one side or the water supply or drainage is not good.
(P. 16 “U 11” “U 14”)
Main unit
No operation
●
Power failure?
●
Is the lid closed completely?
● Has the power fuse blown or the breaker tripped?
●
Is the power plug inserted completely?
●
Is the water faucet turned on?
●
Did you press “Start”?
●
Is the timer reservation set?
W
ash
No water supply
●
Is the water faucet turned on?
●
Water outage?
● Is the water supply filter clogged with dirt?
(P. 13)
Water is supplied in the
middle of wash process.
●
If the water level drops, water is added automatically.
●
With a large amount of laundry, water is added several times
automatically.
The water level is too high
for the amount of laundry.
●
If laundry is wet or there is water in the tub before operation,
the water level may be higher.
The water level is too low for
the amount of laundry.
● With light clothes (of synthetic fibre, etc.), the water level may
be lower.
Rinse/Spin
Operation started with rinse,
but water is not supplied.
●
If there is no water in the tub, water is supplied after spin.
●
If there is water in the tub, water is supplied after water
discharge.
Operation suddenly changes
to rinse process in the
middle of spin.
Only spin is desired, but
operation starts with rinse.
●
If clothes are concentrated on one side of the tub, the washing
machine automatically corrects unevenness by starting rinse
process.
(Place clothes as evenly as possible.)
Irregular rotation during spin
●
The tub rotation speed is adjusted to reduce foaming during
spin.
Others
Power failure /
The breaker has tripped.
●
Operation will resume from the point where it was stopped
when the power is recovered (Auto Restart).
Water outage
●
When water supply is recovered, remove the water supply
hose, release turbid water from the faucet, and then start the
washing machine.
The “Stain ”
program has no effect
(Stains are not removed).
●
Pretreatments have been performed? (Hand washing, applying
stain remover, etc.)
●
The amount of laundry is under 2.0
k
g
?
(P. 6)
●
The “Stain ” program is selected according to the type
of stains?
(P. 6)
Powder detergent remains
undissolved.
●
Put the detergent in the detergent inlet.
(P. 5)
