Washing Instructions - 17
Washing
6. Press the Start button.
The appliance starts supplying water.
After the appliance has started, the
laundry is weighed. After about
5 seconds, a new wash time will be
displayed. If you select the Wool,
Silk/Lingerie, Rapid 15, Shirts,
Sportswear, Bedding, Outdoor or
Denim programmes, the laundry is not
weighed.
The buzzer will sound when the
programme has finished, and the door
will unlock immediately.
Caution
After a high temperature wash, be
careful to not burn yourself when
handling the laundry or touching
the inside of the drum.
Note
-If the detergent is not completely
removed from the laundry by using
the basic programme, use the Extra
Rinse function.
-With the Eco and the Speed
functions, if the load is big, the
laundry may stick to the inside of the
drum. This is normal.
- Remove the laundry and rearrange
where necessary. Do not leave it in
the drum too long after the programme
ends, because colours may run.
Required time
Times depend on the programmes and
temperature settings that have been
selected.
- Actual times may differ slightly from
those shown.
- The displayed times include the time
needed for the water to fill up and to
drain out, thus they vary depending on
water pressure, drainage and amount of
laundry.
- If you change the functions while
washing, the displayed times may
change.
- If the laundry in the drum needs to be
balanced, times will be extended.
Setting the buzzer
The buzzer that sounds when a
programme finishes can be turned off.
1. Press the Start and On buttons at the
same time.
2. Release the On button and keep
pressing the Start button for
3 seconds. The buzzer setting will be
turned off after a beep is heard.
If you wish to reset the setting, perform
the same steps 1 and 2. The buzzer
setting will be turned on after two beeps
are heard.
Changing settings while
washing
After washing has started, the programme,
temperature, and preset time cannot be
changed.
-To change the programme or temperature
settings, turn the appliance off and then
on again.
-To change the rinse or spin settings while
washing, press the Pause button once
the appliance is full of water.
-You can change the Spin-dry revolution,
Extra Rinse and Easy Ironing function
during the washing process.
-No settings can be changed after the
washing process has finished.
NA-140_168_148VG4_WGB_En.indb 17
2013/08/05 13:12:57