40 - Installation Instructions
Checking After Installation
Installation checklist
3
2
4
6
5
7
1
5 6
5 6
1) Anchor bolts
Have you removed them and attached
the cover caps properly?
2) Location
Is the appliance on a flat, stable
surface?
Does it run without vibrating?
3) Water-supply hose
Is it free from leaks?
Is the water supply normal?
4) Water-drain hose
Is it free from leaks?
Does it drain normally?
5) Adjustable stands
Are they bolted securely to the
appliance?
6) Stand cushions
Are they standing flat?
If the appliance is not level, there may
be abnormal sounds when water is
drained out.
7) Power supply
Is the household dedicated mains
socket, fully rated at AC 220 V to 240 V?
Test run after installation
Check for water leakage, abnormal noise,
and proper drainage.
Perform the following procedures
WITHOUT laundry in the drum.
1. Turn on the tap.
2. Close the door.
3. Please spin after moved this washing
machine.
Press the On button. You have to select
“Quick 50” course and “Spin” mode.
Then press the “Start” button.
After the water is drained, start a test run.
4. While holding down the Speed/Eco
and Easy Ironing buttons, press the
On button.
5. When the display appears as below
(3 seconds), press the Speed/Eco button.
The remaining time is displayed as below.
The test is run for about 3 minutes.
Check the following:
- Is there any abnormal noise?
If so, make sure that the appliance is level.
- Is there any water leakage?
If so, make sure that the hoses are
properly connected.
You may get the following errors:
- Are the hoses properly connected?
Is the drain clogged?
- Have you properly connected the water-
supply hose and turned on the tap?
After recovering from an error, reopen and
reclose the door to resume the test.
NA-140_168_148VG4_WGB_En.indb 40
2013/08/05 13:13:04