The mxiture is
leaking.
▶
●
The tumbler unit is not assembled firmly.
➡
Assemble it firmly. (P. EN8)
●
The lid gasket or tumbler base gasket is not attached
firmly.
➡
Attach it them properly.
●
Foreign matters are adhered around the lid gasket or
tumbler base gasket.
➡
Remove the foreign matters.
●
The tumbler base gasket is damaged.
➡
Replace it.
Problem
Cause and Action
●
Lubrication oil might be traced around the upper connector (P.EN7) but it will not
affect the performance. Wipe them off with kitchen paper.
●
"Peep" sound may be heard during operation, but it is not abnormal.
Overloading Protection
In the case of overload, the protection device is triggered to stop operation and it
is not abnormal. After rotation stops, take the following steps.
●
Do not operate the appliance repeatedly without any countermeasure. (Cause of
smoking, unpleasant smell or malfunction)
(Contact Service Centre for inspection or repair if it still does not operate normally.)
Twist tumbler back to "OFF" direction,
remove it from motor housing.
Reduce the ingredients in tumbler to half
●
Remove the prohibited ingredients if it is used.
●
When the blade is stuck with ice cubes, remove it from the tumbler,
for the caught one around the blade, remove it by flushing water.
●
For smoothie etc. with high viscosity or low moisture, reduce the
ingredients and add more liquid.
●
Rest the appliance for more than 1 minute.
Reset the tumbler, start blending again.
1
2
3
Even though
the tumbler is
twisted to
"ON" direction,
the appliance
does not start
blending.
▶
●
The tumbler unit is not attached with the motor housing
properly.
➡
When attaching it, make sure the mark on tumbler
base and motor housing have been aligned, then twist
it firmly until you hear a "click" sound.
●
The tumbler base is not attached tightly.
➡
Assemble it tightly.
●
The power plug is disconnected.
➡
Insert the power plug into outlet firmly.
●
Ingredients are stuck around the blade.
➡
Remove all ingredients and then replace them.
The blade is
Idling.
▶
●
The liquid amount is not enough.
➡
Add more liquid.
●
Too much ice cubes.
（
e.g. juice with a lot of ice
）
➡①
Twist the tumbler back to "OFF" direction, remove
tumbler after rotation stop completely.
②
Shake the tumbler gently.
• If it happens again, reduce the ingredients.
The appliance
stops during
blending.
▶
●
The overloading protection device is activated.
•
Prohibited ingredients are added.
•
Too much ingredients are used.
•
Ingredients are too large.
•
Ingredients are too hard. (e.g. shaved ice)
•
There is abnormal noise or vibration is too large.
➡
Refer to “Overloading Protection” for inspection.(P.EN15)
If prohibited ingredients are used, remove them.
There is
abnormal
noise or
vibration.
▶
●
Too much ingredients.
➡
Twist tumbler to "OFF" direction and reduce ingredient amount.
●
The tumbler unit is not assembled firmly.
➡
Assemble it firmly. (P. EN8)
EN15
