Even though
the tumbler is
twisted to
"ON" direction,
the appliance
does not start
blending.
▶
●
The tumbler unit is not attached with the motor housing
properly.
➡
When attaching it, make sure the mark on tumbler
base and motor housing have been aligned, then twist
it firmly until you hear a "click" sound.
●
The tumbler base is not attached tightly.
➡
Assemble it tightly.
●
The power plug is disconnected.
➡
Insert the power plug into outlet firmly.
●
Ingredients are stuck around the blade.
➡
Remove all ingredients and then replace them.
The blade is
Idling.
▶
●
The liquid amount is not enough.
➡
Add more liquid.
●
Too much ice cubes.
（
e.g. juice with a lot of ice
）
➡①
Twist the tumbler back to "OFF" direction, remove
tumbler after rotation stop completely.
②
Shake the tumbler gently.
• If it happens again, reduce the ingredients.
The appliance
stops during
blending.
▶
●
The overloading protection device is activated.
•
Prohibited ingredients are added.
•
Too much ingredients are used.
•
Ingredients are too large.
•
Ingredients are too hard. (e.g. shaved ice)
•
There is abnormal noise or vibration is too large.
➡
Refer to “Overloading Protection” for inspection.(P.EN15)
If prohibited ingredients are used, remove them.
There is
abnormal
noise or
vibration.
▶
●
Too much ingredients.
➡
Twist tumbler to "OFF" direction and reduce ingredient amount.
●
The tumbler unit is not assembled firmly.
➡
Assemble it firmly. (P. EN8)
Troubleshooting
Check following points before calling or arranging for repair.
Problem
Cause and Action
EN14
