EN3
English
CAUTION
To prevent electric shock, fi re caused by a short circuit, burning, injury
or smoke.
ƪ
Do not replace any parts of the appliance with non-genuine spare parts.
ƪ
Do not leave the appliance unattended when it is in operation.
• When leaving the appliance unattended, turn the power Off.
ƪ
Do not use the appliance on following places:
• Any uneven surface, on non-heat resistant carpet, table cloth, etc.
• The place where it may be splashed with water or near a heat source.
ƪ
Do not blend more than 1 L working capacity marked on the Blender Jug.
ƪ
Do not place more than the maximum working capacity allowed for the Mill Container. Follow the
recommended ingredient amount for processing. (See page EN8 "How to Use Dry Mill".)
ƪ
Do not operate without the Blender Lid in place correctly for the Blender Jug.
ƪ
Make sure to hold the Plug when unplugging. Never pull on the Cord.
ƪ
Ensure to operate and rest the appliance based on the table below:
Function
Operating Time
(minutes)
Rest Time
(minutes)
Blender
2
2
Dry Mill
1
2
ƪ
Unplug the appliance when not in use.
ƪ
When carrying the appliance, be sure to hold the Motor Housing with both hands.
ƪ
Switch off the appliance and disconnect from the power supply before changing accessories or
approaching parts that move in use.
ƪ
Care shall be taken when handling the sharp Cutting Blades, emptying the Blender Jug or the Mill
Container and during cleaning.
ƪ
Operate the appliance on a clean, fl at, hard and dry surface.
ƪ
If the Blender Cutting Blade gets stuck, switch off immediately and unplug. Do not insert fi nger into the
Blender Jug. Use the Scraper to remove the ingredients that are blocking the Blender Cutting Blade.
ƪ
This product is intended for household use only.
ƪ
Ensure to clean the surfaces in contact with food after use. (See Page EN9 "After Use".)
WARNING
ƪ
Insert the Plug fi rmly.
• Otherwise it may cause electric shock and fi re caused by the heat that may generate around the Plug.
ƪ
Clean the Plug regularly.
• A soiled Plug may cause insuffi cient insulation due to the moisture, and may cause fi re.
ƪ
Discontinue using the appliance immediately and unplug in the unlikely event that this appliance stops
working properly.
e.g. for abnormal occurrences or breaking down:
• The Plug or the Cord becomes abnormally hot.
• The Cord is damaged or there has been a power failure.
• The Motor Housing is deformed, has visible damage or is abnormally hot.
→
Please unplug the appliance immediately and contact the Service Centre for advice or a repair.
ƪ
Be careful if hot liquid is poured into the Blender Jug as it can be ejected out of the appliance due to a
sudden steaming.
Blender_MX-M300_210_200_100_EVT.indb 3
Blender_MX-M300_210_200_100_EVT.indb 3
6/11/2019 11:58:49 AM
6/11/2019 11:58:49 AM
