Panasonic MC-E4051, Operating Instructions Manual

Page: 14 / 18

- 14 -
I) TROUBLE SHOOTING GUIDE
Before contacting your Pansonic service centre, check the following points:
NOTE: Failure to correctly maintain your product, for example regular cleaning and unblocking, may result in a charge if referred
to a service agent for attention.
CAUTION:DISCONNECT from the mains socket before carrying out any kind of maintenance opera-
tion.
TROUBLE CHECK POINT CAUSE / REMEDY
Motor fails to rotate • Mains plug connection • Check that the mains plug is connected firmly and
(no noise is heard at all) mains socket is ON.
• Mains plug fuse. (UK, IRL only) • Check fuse and replace if blown.
• Thermal cut-out device may have • (See Thermal cut-out protection feature below
operated. described).
Motor runs but there • Hose inlet is blocked. • If there is a blockage, remove it.
is no suction. see (BLOCKAGES)
• Check dust mark. • If it shows full, empty the dust compartment.
• Primary filter • If the primary filter is full of dust, clean it or
replace. (see FILTER CARE)
• Check hose is properly inserted • Re-insert the hose to suction pipe inlet correctly.
to the suction pipe inlet.
• Check dust accumulated on primary • Remove dust accumulated or replace the filters.
filter. (see FILTER CARE)
• Exhaust filter. • If exhaust filter is full of dust, clean or replace it.
(see FILTER CARE)
• Dust compartment inlet is blocked. • If there is a blockage, remove it.
(see BLOCKAGES)
Beater bar does not • Clogged by a large object in • If there is any obstruction, remove it.
rotate. the beater bar housing.
• Belts broken or loose. • If the belt is broken, replace it.
If loose re-install it.
THERMAL CUT-OUT
This vacuum cleaner is fitted with a thermal cut-out device which automatically turns off the cleaner to prevent overheating of the
motor. When this happens, disconnect the cleaner from the mains socket and check the dust compartment and filters as it may
be full or clogged with fine dust. Check for any other obstructions.
After emptying the dust compartment or removing the obstruction, leave the vacuum cleaner to cool down until the thermal cut-
out resets after approximately 40 minutes.
IMPORTANT: The thermal cut-out will not reset if the unit is not disconnected from the mains socket.
MAINS LEAD
IMPORTANT: If the mains lead becomes damaged, it must be repaired by Panasonic, authorised service centre or a
qualified person in order to avoid any hazard.