– 6 –
F) HOW TO EMPTY THE DUST COMPARTMENT
Press locks at both sides to remove the
dust compartment.
Press the clip and pull the cover up.
Remove dust compartment cover.
Empty the dust into a bag or a waste bin.
Clean the pre-filter by brushing the dust
off with a soft brush.
Open the cover and remove dust
accumulated in the filter
A
and filter
B
by tapping them against a hard surface.
If dust remains on filter
A
, replace with
the spare or carry out further cleaning
detailed on following page.
Pass the lock through the dust
compartment slot.
Replace the dust compartment
assembly into the main body.
MAINTENANCE AND SERVICING
IMPORTANT: Before servicing any part, always
DISCONNECT THE CLEANER FROM THE MAINS SUPPLY.
IMPORTANT:
Depending on the type of dust, one of the two compartments may get full before the other.
If either becomes full, reaching the dust maximum mark, please empty both.
IMPORTANT: If after having
emptied the dust compartment
the airflow is not enough,
check for any possible
blockage. Clean up filters if
very dirty. (see FILTER CARE)
NOTE:
When vacuuming fine dust such as powder or similar, there may be a loss of suction power.
If this happens, empty the dust compartment and check for possible dust trapped on filters.
NOTE: The dust compartment may be washed with warm water.
DO NOT use detergents or other cleaning fluids to avoid deterioration of the plastic.
DO NOT attempt to clean the dust compartment in a dishwasher.
IMPORTANT: Before re-assembling the dust compartment, ensure it is completely dry.
1
2
3
4
5
6
8
9
1
2
Insert claws in to the dust compartment
cover slots.
7
Claws
A
B
