9
4.4.
Motor removal
1. Lift the motor section from the lower body U.
2. Remove the components fitted to the motor.
a. Remove the thermal protector.
b. Remove the motor support rubber (rear).
c. Remove the motor support.
d. Remove the lead wires connected to the motor.
e. Remove the noise suppressor.
f. Remove the motor support rubber (front).
* Note: When the thermal protector has been
replaced, make sure to paste the tape (gasket V) back
on the terminals.
4.5.
Replacement of the indicator
ornamental plate unit
1. Remove the three screws fixing the air inlet guide on the
rear of the dust box lid assy.
2. Hook off the two fixing tabs on the indicator ornamental
plate unit with a flat-blade screwdriver.
