18 Object group settings
• You can specify different parameters to correct the marking position.
The following figure shows these parameters.
+Y
-Z
+X
-X
+Z
+
-
-Y
(1)
(2)
(3)
(5)
(4)
(1) X-movement
(2) Y-movement
(3) Z-movement
(4) Rotation (-)
(5) Rotation (+)
‒ “ X-movement [mm]”, “Y-movement [mm]”:
Enter a value to move all marking data in the object group along the x-axis and y-
axis.
The orientation of the x- and y-axis is defined by the head direction setting.
‒ “ Z-movement [mm]” (LP-GS except LP-GS051-L):
Enter a value to position all marking data in the object group along the z-axis.
‒ “Rotation movement [°]”:
Specify an angle to rotate all marking data in the object group. The rotation center is
the center of the marking field. Enter a positive value for counterclockwise rotation
and a negative value for clockwise rotation.
Related topics
General object/object group parameters
18.3 Set object group parameters
Specify parameters for the object group. The settings apply to all marking data in the
selected object group.
• To edit the parameters of an object group, select the object group in the object list.
The parameters are displayed in the category below the object list.
Specify any of the following parameters:
ME-NAVIS2-OP-1
193
