14
English
•The shaving sensor may not respond depending on the type and
quantity of the shaving gel or the quantity of the foam. This is not
abnormal.
•
To prevent erroneous operation, place your fingers on the finger
rest while using the shaver.
Operation and display of the switch lock
►
Locking the power switch
1. Press
once
and then release.
•The shaver
starts operating.
2. Press
for more
than 2 seconds.
•The switch lock
lamp ( ) will
light up for
5 seconds and
turn off.
•The shaver will
stop operating.
3. Release
.
►
Unlocking the power switch
1. Press
for more than
2 seconds.
•The switch lock lamp ( )
will turn off.
2. Once the shaver starts
operating, release
.
•The power switch cannot be unlocked while charging.
•The power switch is locked when the switch lock lamp ( ) blinks
for 5 seconds and the shaver does not operate even though the
power switch is pressed.
Cleaning the shaver
We recommend cleaning the shaver after each use.
1. Turn the shaver off and disconnect the AC adaptor.
2. Apply some hand soap and some water to the
system outer foil.
•Close the cleaning shutter.
3. Turn the shaver on.
•Hold the power switch for 2 seconds or more
to switch to shaving foam mode.
ES-BST6Q
▼
There are two ways to clean the shaver, depending on the
actual dirt level�
▼
▼
Summary of Contents for Lamdash ES-BST6Q
Page 2: ...2 ...