Panasonic KX-TVP50, Installation Manual

Page: 62 / 380

INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX
62 Installation Manual
Recommended Outside (CO) Line feature settings:
a)
If the VPS is answering all incoming calls:
Outside (CO) Line Mode—Use System Programmes [414] (Day Mode), [415]
(Night Mode), [416] (Lunch Mode) to set this parameter. Program all lines DIL to the
first extension of the Voice Mail hunt group. The KX-TA series will allow incoming
outside calls to hunt only if the outside (CO) lines are DIL to the first port of the hunt
group. Lines programmed as "Normal" do not hunt.
b)
If the VPS is only answering calls not answered by the operator (Operator Backup):
Flexible Ringing Assignment—For each outside (CO) line, use System
Programmes [408] (Day mode), [409] (Night Mode) and [410] (Lunch Mode) to
enable ringing at the operator’s extension (jack).
Delayed Ringing Assignment—To give the operator time to answer the call before
the VPS picks up, we recommend setting the delay to 3 or 4 rings for each extension
connected to the VPS. Use System Programmes [411] (Day Mode), [412] (Night
Mode) and [413] (Lunch Mode).
Outside (CO) Line Mode—Set the mode for each outside (CO) line to "Normal".
Use System Programmes [414] (Day Mode), [415] (Night Mode) and [416] (Lunch
Mode) to set this parameter.
c)
If the VPS is only answering calls not answered by user extensions:
Flexible Ringing Assignment—For each outside (CO) line, use System
Programmes [408] (Day Mode), [409] (Night Mode) and [410] (Lunch Mode) to
enable ringing on every extension (jack) that you want to have ring.
Delayed Ringing Assignment—To give users time to answer the call before the VPS
picks up, we recommend setting the delay to 3 or 4 rings for each extension
connected to the VPS. Use System Programmes [411] (Day Mode), [412] (Night
Mode) and [413] (Lunch Mode).
Outside (CO) Line Mode—Set the mode for each outside (CO) line to "Normal".
Use System Programmes [414] (Day Mode), [415] (Night Mode) and [416] (Lunch
Mode) to set this parameter.
6.
Connect the jack(s) assigned in Step 3 to the VPS.
7.
Connect your personal computer to the VPS and start your communication software (i.e.,
HyperTerminal, Procomm Plus, Smartcom...).
8.
Disconnect the power from the VPS and set the DIP Switch to position 5.
Only perform this step when initially setting up the system.
Table 14 2 Outside (CO) Lines, 2 Ports
Outside (CO)
Lines
Ports
1 1, 2
2 1, 2