Panasonic KX-TGD320AL, Operating Instructions Manual

Page: 27 / 52

Main menu: “ Ringer Setup ”
*13
Sub-menu 1 Sub-menu 2 Settings Code
Ringer Volume Handset
Off
-6 <6> #160 –
Base Unit
*1
Off
-6 <3> # G 160 –
Ringtone
*4
(Handset)
– <
Ringtone 1
> #161 –
Do Not Disturb
Mode On/Off On
<
Off
>
#238 29
Start/End
<23:00/06:00> #237 29
Ring Delay 30 sec.
<
60 sec.
>
90 sec.
120 sec.
No Ringing
#239 29
Select Category Category 1-9 #241 29
First Ring
*1, *5 – <
On
>
Off
#173 –
*1 If you program these settings using one of the handsets, you do not need to program the
same item using another handset.
*2 This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*3 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select
“
Caller ID
” . To turn this feature off, select “
Manual
” .
(Caller ID subscribers only)
To use this feature, set the date and time first (page 13).
*4 The preset melodies in this product are used with the following permission:
– “ Ringtone 3 ” : © 2014 Copyrights Vision Inc.
– “ Ringtone 4 ” - “ Ringtone 40 ” : © 2012 Copyrights Vision Inc.
*5 If you do not want the unit to ring before the caller information is received, set to “
Off
” .
(Caller ID subscribers only)
You can only remove the first ring if the unit rings 2 times or more by default, which depends
on your phone service provider.
*6 This setting is available when you have the key finder (KX-TGA20AZ). Read the installation
manual for more information on the key finder.
*7 For models with supplied key finders, the display shows “
1:Finder1
” .
*8 If you register 2 or more key finders.
*9 This menu is not displayed when repeater mode is set to
“
On
” .
*10 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up
the handset to answer a call, turn off this feature.
*11 The recall/flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary.
You can access your phone service provider “call waiting” service by having the recall/flash
time set at
“
100 msec.
” , and then follow your phone service provider “call waiting”
instructions to operate this service.
27
Programming
TGD32xAL(en)_1103_ver021.pdf 27 3/11/2015 1:59:52 PM