Turning do not disturb mode on/off
1
M
MENU
N#238
2
MbN
: Select the desired setting.
a
M
OK
N
R
If you select
“
Off
”
, press
M
OFF
N
to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
a
M
OK
N
4
Enter the desired hour and minute you
wish to end this feature.
a
M
OK
N
a
M
OFF
N
Changing the start and end time
1
M
MENU
N#237
2
Continue from step 3, “Turning do not
disturb mode on/off”, page 29.
Setting the ring delay
This setting allows the handset to ring during
do not disturb mode if the caller waits long
enough. After the selected amount of time
passes, the handset rings. If you select
“
No
Ringing
”
, the handset never rings during do
not disturb mode.
1
M
MENU
N#239
2
MbN
: Select the desired setting.
a
M
OK
N
a
M
OFF
N
Note:
R
When the answering system answers the
call, this feature does not work.
Selecting categories to bypass do
not disturb mode
1
M
MENU
N#241
2
MbN
: Select the desired categories.
a
M
SELECT
N
R
“ ” is displayed next to the selected
category numbers.
R
To cancel the selected category:
MbN
: Select the category.
a
Press
M
SELECT
N
again. “ ” disappears.
3
M
OK
N
a
M
OFF
N
Nuisance call block
This feature blocks calls from unwanted
callers (Caller ID subscribers only). The
following items are available when storing
phone numbers in the call block list (50 max.).
–
“
Single Number
”
: The unit blocks calls
from specific phone numbers.
–
“
Range of Numbers
”
: The unit blocks
calls that begin with a number stored in the
call block list, such as a toll-free phone
number prefix or certain area codes.
You can also set the unit to block calls that
have no phone number.
When a call is received, the unit does not ring
while the caller is being identified. If the
caller’s phone number matches an entry in the
call block list, the unit emits no sound to the
caller, and disconnects the call.
Important:
R
Blocked calls are logged in the caller list.
Storing unwanted callers
Storing a single phone number
Important:
R
You must include the area code when
storing phone numbers in the call block list.
n
From the caller list:
1
MCN
CID
2
MbN
: Select the entry to be blocked.
a
M
MENU
N
3
MbN
:
“
Save Call Block
”
a
M
OK
N
4
MbN
:
“
Yes
”
a
M
OK
N
a
M
OFF
N
n
By entering phone numbers:
1
M
MENU
N#217
2
MbN
:
“
Single Number
”
a
M
OK
N
3
M
MENU
N
a
MbN
:
“
Add
”
a
M
OK
N
4
Enter the phone number (24 digits max.).
R
To erase a digit, press
M
CLEAR
N
.
5
M
OK
N
a
M
OFF
N
Storing a range of numbers
1
M
MENU
N#217
29
Programming
TGD32xAL(en)_1103_ver021.pdf 29
3/11/2015 1:59:52 PM
