Panasonic KX-TEM824, Features Manual

Page: 157 / 298

1.20 Administrative Information Features
Feature Guide 157
Conditions
• SMDR data is not deleted even if the PBX is restarted. It is cleared when output via RS-232C to a PC,
printer, etc., or by performing System Data Clear.
• Multilingual Display by SMDR
It is possible to select the display language used for SMDR through system programming ( SMDR
Language [806]).
• The PBX waits for a preprogrammed length of time ( Call Duration Counter Start [204]) after the end
of seizing an outside (CO) line or dialling before starting the SMDR timer for outgoing outside (CO) line
calls. When the PBX has sent out all dialled digits to the telephone company and this timer expires, the
PBX begins measuring the duration of the call. A display proprietary telephone (PT) shows the elapsed
time of the call. The starting time and the total duration of the call are logged by SMDR.
If Reverse Signal Detection is enabled for an outside (CO) line (
Polarity Reverse Detection [424]),
the PBX will automatically start the timer ( Call Duration Counter Start [204]) immediately after the
outside party answers the call.
• For SMS users
When an SLT user makes an SMS centre call ( 1.17.3 Fixed Line SMS Terminal Support), in some
cases the duration of the call may not be verified with SMDR, because it takes very little time to send
SMS messages. To verify the duration of these calls, it is recommended to set the start timer of call
duration to "5 s" or "Instantly" through system programming (
Call Duration Counter Start [204]).
• SMDR Format
The following SMDR format parameters can be set through system programming ( SMDR Parameter
[801]) in order to match the paper size being used by the printer:
a)
Page Length : determines the number of lines per page.
b)
Skip Perforation : determines the number of lines to be skipped at the end of every page.
The page length should be at least 4 lines longer than the skip perforation length.
The title is placed on the first 3 lines of every page.
To enable the changes, you must turn the power switch of the PBX off and back on again after changing
this setting.
System programming items Controls whether system programming items that have already been
assigned are shown based on the following parameters (
System
Data Dump [804]):
a)
All para : All data
b)
System para : All data except for "CO para", "Extn. para",
"DSS para" and "Speed dial"
c)
CO para : The data assigned for each outside (CO) line
d)
Extn. para : The data assigned for each extension
e)
DSS para : The data assigned on the Direct Station
Selection (DSS) buttons and Programmable Feature (PF)
buttons on the DSS Console
f)
Speed dial : The System Speed Dialling numbers and
names in System Speed Dialling Number [001] and System
Speed Dialling Name [011]
g)
Stop output : Not shown
Item Description