78
Before Requesting Help
Problem
The answering system is on,
but incoming messages are
not recorded.
You cannot listen to the
recorded messages.
“
” is displayed and the
ANSWER ON indicator
flashes rapidly, and no new
messages are recorded.
You cannot operate the
answering system at the
base unit.
You cannot operate the
answering system from a
touch tone phone.
You cannot operate the
answering system with the
handset.
While recording a greeting
message, the unit starts to
ring and stops recording.
FULL
Remedy
•
The recording time is set to “Greeting
only”. Select “1 minute” or “3 minutes”
(p. 26).
•
Memory is full. Erase some, or all, of the
messages (p. 61).
•
Make sure that the unit is in the standby
mode.
•
Memory is full. Erase some, or all, of the
messages (p. 61).
•
The handset user is operating the
answering system, or is engaged in an
outside call. Wait until the IN
USE/CHARGE indicator light goes out.
•
Make sure you enter the correct remote
code.
•
The answering system may not respond
if the tones are too short to activate the
unit. Press each button firmly.
•
The answering system is off. Turn it on
(p. 57).
•
Someone is operating the answering
system.
•
You are too far from the base unit. Move
closer to the base unit.
•
The unit is recording a message.
To answer the call, press
(TALK)
or
(DIGITAL!SP-PHONE)
.
•
To answer the call, press
(DIGITAL!SP-PHONE)
or press
(TALK)
.
Start again from the beginning after
hanging up.
Answering System
