23
Open the front door and check whether the
media is jammed under the color imaging unit.
If the media jam is not found, go to next step.
B
If the media is jammed, remove it by
following Method B of Jam at B.
To clear error message “Jam at C”, slide out
the fuser unit, then slide it back to the printer.
#
Turn the green thumbscrew
counterclockwise.
$
Holding the green tab, slide the fuser unit
out until it stops
.
%
Press the green lever.
Hold the fuser unit (see above) and slide it out
and close the front door.
SAFETY CAUTION:
B
The fuser unit weighs approximately 3.1 k
g
{6.8 lbs.}. Take care when handling it.
Press out on tabs to unlock and remove the oil
supply roll out of the fuser unit.
Note:
B
If the paper is not jammed in the fuser unit,
perform Method B of Jam at B on page 22.
#
Turn the fuser unit’s green knob clockwise.
$
Remove the jammed media.
Note:
B
If needed, you can remove the cleaning pad to
remove the jammed media.
SAFETY CAUTION:
B
Do not touch the roller and the parts around the
roller when handling the fuser unit, because they
may be hot.
3
2
Jam at C
SAFETY CAUTION:
The fuser unit is hot; to avoid personal
injury, turn off the printer and wait 10
minutes (after opening the front door) for
the fuser unit to cool before touching it.
!
Jammed media
1
#
%
CAUTION:
HOT SURFACE INSIDE
5
4
#
$
#
Cleaning pad
Green Knob
$
#
$
(continued)
Maintenance
Reference
Guide
Summary of Contents for KX-P8415
Page 16: ...16...