TRD2 (+)
4
4
TRD2 (+)
TRD2 (−)
5
5
TRD2 (−)
TRD1 (−)
6
6
TRD1 (−)
TRD3 (+)
7
7
TRD3 (+)
TRD3 (−)
8
8
TRD3 (−)
Note
•
Use an Ethernet cable with an RJ45 connector for connection to a switching hub. The cable should
be a CAT 5 (Category 5) or higher for 10BASE-T/100BASE-TX, or CAT 5e (Enhanced Category 5)
or higher for 1000BASE-T.
•
Make sure that all CAT 5/CAT 5e cables in use are not over 100 m (328 ft) in length.
•
Make sure to set the port of the switching hub that connects to the card to operate under "Auto Ne-
gotiation" mode.
•
Make sure to create a spanning tree for LAN connection in order to prevent loops from occurring in a
multi-bridged environment. Otherwise, some packets may circulate for long periods of time and
eventually PBX performance system may degrade.
•
When using the VLAN feature on the network, make sure that the PBX is connected to a layer 2
switch that is IEEE 802.1Q compliant, and that is configured for VLANs. In addition, the port of the
switching hub to which the PBX is connected must be set to "Untagged". Consult your network ad-
ministrator for details.
3.12.2 Wireless LAN Connection
Connecting the Main Unit to the Wireless LAN
Smartphone
(Softphone)
PC
1.
Perform settings for the Wireless LAN connection of the HTS Series.
Change the SSID and the Passphrase.
Also change other settings as necessary.
For details about the Wireless LAN Connection, refer to "Network Configuration-6.Wireless" in the Pro-
gramming Item List.
2.
Wireless extension connections
Select one of the following connection methods for using the Wi-Fi function of the wireless extension.
a.
Connection using the WPS button
•
Refer to the instruction manual of the wireless extension and configure it to enable WPS.
•
Press and hold the WPS button on the side of the HTS Series unit for 3 seconds. (STATUS Indi-
cator : Green flashing (240/minute) - Wi-Fi Protected Setup (WPS) in progress)
3.12.2 Wireless LAN Connection
88
