3.8 Starting the PBX
WARNING
Make sure that the AC outlet is properly earthed, then securely connect the 3-pin AC plug including the
earthed pin.
CAUTION
•
Use only the AC power cord included with the PBX.
•
Before touching the product (PBX, cards, etc.), discharge static electricity by touching ground or
wearing an earthing strap. Failure to do so may cause the PBX to malfunction due to static electrici-
ty.
•
Once you have started the PBX, if you unplug the PBX, do not initialise it again as described in
"System Initialisation Procedure". Otherwise, your programmed data will be cleared. To restart the
PBX, refer to "6.1.4 Restarting the PBX".
•
The plug of power supply cordset is used as the main disconnect device. Ensure that the AC outlet
is located near the equipment and is easily accessible.
Connecting the AC Power Cord
Note
For safety reasons, do not stretch or pinch the AC power cord.
System Initialisation Procedure
The system can be reset to its original default state by pressing the Initialize switch while turning the system
power on.
The system initialisation startup operation is as follows.
•
Turn on the system power and press and hold the Initialize switch (for 3 seconds).
1.
Initialize switch press and hold (3 seconds) recognised: Green (high-speed flashing at 120 flashes/
minute)
2.
Initialize switch press and hold (3 seconds) confirmed: Amber (flashes 3 times)
3.
Initialise process and system startup process: Green (low-speed flashing at 60 flashes/minute)
•
When system initialisation is complete, operation begins (green LED illuminated).
Performing a system initialisation returns the system data to its default settings.
The memory state is also cleared.
3.8 Starting the PBX
78
