Part names and functions
J
C D
F
E
B
A
I
H
G
Microphone
Sensor range cap (Standard)
Infrared sensor
LED indicator
Lens unit
Speaker
M
N
Used when registering the camera to the
hub.
Safety wire
Camera mounting stand
DC cable
LED indicator
You can use the LED indicator to confirm the
camera’s status.
Indicator
Status
Off
No power, or LED
indicator is turned
off
*1
Green, lit
Normal operation
*1
Green, blinking
slowly
Registration mode
Red
Motion detected
Indicator
Status
Red, blinking slowly
Live images are
being viewed or
recorded
Red, blinking
Camera is out of
range of the hub, or
device malfunction
Amber, blinking
slowly
Camera is not
registered to a hub
*1 You can configure the camera so that its
LED indicator does not light during
normal operation. For more information,
refer to the User’s Guide (page 29).
Setup overview
1
Initial setup
Make sure you can access the system
using your mobile device. For details,
refer to the System Setup Guide included
with your hub.
2
Registration
Required only if the camera was
purchased separately (i.e., not as part of
a bundle).
3
Confirm the installation area
Read the information in this document to
confirm that the desired installation area
is suitable to proper operation.
4
Installation
Install the camera in the desired location
and connect the camera to the power
outlet.
5
Adjust the infrared sensor range
Confirm the sensor range area and adjust
it if necessary using the included sensor
range adjustment caps.
18
Helpline Tel. No.: U.K. 0330 3331112 Ireland 01 4475228
Setup
HNC600E_(en_en)_1227_ver.102.pdf 18
2016/12/27 23:35:22
