Panasonic KX-HCM8 - Network Camera - Position, Operating Instructions Manual

Page: 107 / 118

Operating Instructions
[For assistance, please call: 1-800-272-7033] 107
Power Indicator
continues
blinking. • Internal Failure of the server or the congestion on the network
traffic when using DHCP may prevent Network Camera from
getting the IP address. Ask the network administrator or your
ISP.
• Power Indicator blinks when updating firmware on page 82.
When the Update Firmware failed, refer to page 108.
• If you cannot access Network Camera, the Network Camera
hardware may be defective. Call our customer call center.
Image Transfer
on e-mail or FTP
does not work. • Default Gateway and DNS server address should be set up on
Network window on page 50.
• If FTP does not work properly, ask your ISP or network
administrator about the transferring mode of FTP server.
[Passive Mode] or [Active Mode] is available.
• Select [One Time] for Login Timing when transferring images
by FTP in short duration time.
Timer mode
transfers older
images. Short interval of Image Buffer Frequency makes Network Camera
transfer the older images. Set the interval long enough to transfer
the images. Buffered Image screen enables you to check this
setting.
About Network Camera Setup
Problem Cause and Remedy