8. Help
52
8 Help
Error Messages
8.1 Error messages –
Reports
If a problem occurs during fax transmission or
reception, one of the following communication
messages will be printed on the sending and
journal reports (page 25).
COMMUNICATION ERROR
(Code: 40-42, 46-72, FF)
L
A transmission or reception error occurred.
Try again or check with the other party.
COMMUNICATION ERROR
(Code: 43, 44)
L
A line problem occurred. Connect the
telephone line cord to a different jack and try
again.
L
An overseas transmission error occurred. Try
using the overseas mode (feature #23, page
45).
DOCUMENT JAMMED
L
The document is jammed. Remove the
jammed document (page 60).
ERROR-NOT YOUR UNIT
(Code: 54, 59, 70)
L
A transmission or reception error occurred
because of a problem with the other party’s
fax machine. Check with the other party.
JUNK FAX PROH. REJECT
L
The junk fax prohibitor of your fax machine
rejected fax reception.
MEMORY FULL
L
The memory is full of received documents
due to a lack of recording paper or a
recording paper jam. Install paper (page 13)
or clear the jammed paper (page 58).
NO DOCUMENT
L
The document was not fed into the unit
properly. Re-insert it and try again.
OTHER FAX NOT RESPONDING
L
The other party’s fax machine is busy or has
run out of recording paper. Try again.
L
The document was not fed properly. Re-
insert the document and try again.
L
The other party’s fax machine rings too many
times. Send the fax manually (page 24).
L
The other party’s machine is not a fax
machine. Check with the other party.
L
The number you dialled is not in service.
PRESSED THE STOP KEY
L {
STOP
}
was pressed and fax communication
was cancelled.
OK
L
Fax communication was successful.
8.2 Error messages –
Display
If the unit detects a problem, one or more of the
following messages will appear on the display.
—————————————————————
CALL SERVICE
CALL SERVICE 2
L
There is something wrong with the unit.
Contact our service personnel.
—————————————————————
CHECK DOCUMENT
L
The document was not fed into the unit
properly. Re-insert the document. If
misfeeding occurs frequently, clean the
document feeder rollers (page 62) and try
again.
L
Attempted to transmit a document longer
than 600 mm. Press
{
STOP
}
to remove the
document. Divide the document into two or
more sheets and try again.
—————————————————————
CHECK FILM
L
The ink film is empty. Replace the ink film
with a new one (page 12).
L
The ink film is not installed. Install it (page
10).
L
The ink film is slack or creased. Tighten it
(see step 5 on page 11).
—————————————————————
CHECK MEMORY
L
The memory (telephone numbers,
parameters, etc.) has been erased. Re-
program.
—————————————————————
CHECK PAPER
L
The recording paper is not installed or the
unit has run out of paper. Install paper and
press
{
START
}
to clear the message.
FP143-148RU_en.book Page 52 Thursday, October 30, 2003 11:55 AM
