108
Operations
Problem
Cause & Remedy
≥
Possible causes are as follows.
—Telephone circuit is not good.
—You received a call-waiting signal.
—The other party stopped reception.
—The other party ran out of recording paper.
Transmit again after confirming with the other party.
≥
The other party did not answer the call or the line was busy.
Transmit again after waiting a while.
≥
The dialling mode setting (tone or pulse) is not correct.
Open the Setup dialogue box and confirm the dialling mode setup
check box in the Line tab.
≥
Set the fax machine to the overseas transmission mode (p. 52).
The “Sending a fax failed.” message
is displayed.
The “No response” message is
displayed.
I cannot make an international
transmission.
Transmission
Problem
Cause & Remedy
≥
You may have checked the [Receive directly to Facsimile Unit]
check box in the Reception tab in the Setup dialogue box. If so,
click this check box to deactivate.
≥
The setting of the PC LINK on the fax machine is off. Turn it on
(p. 99).
≥
The PANA LINK application is not operating. Start the PANA LINK
application.
≥
Open the Setup dialogue box, and check the [Receive directly to
Facsimile Unit] check box in the Reception tab.
≥
Print after selecting the desired printer from the Print dialogue box.
≥
Possible causes are as follows.
—The line condition was not good.
—The call waiting signal interfered with reception.
Check with the other party and try again.
The fax machine receives a fax, but I
want to receive it with the PC.
The PC receives a fax, but I want to
receive it with the fax machine.
I want to print out the received fax
with another printer.
The “Receiving a fax failed.”
message is displayed.
Reception
Problem
Cause & Remedy
≥
The facsimile unit is probably busy. Try again after the other
operation is completed.
≥
There might not be enough free space on the hard disk. Try again
after deleting unnecessary files or closing unused applications.
≥
There might not be enough RAM. Try again after closing some
applications.
≥
Restart the PC, and try again.
≥
Confirm that a maximum of 15 pages are set correctly.
≥
If you select Fine (200
k
200 dpi) in the image quality list, make
sure the document is less than 655 mm. If you select Line Art
(400
k
400 dpi), make sure the document is less than 470 mm.
Remove the jammed document and try again.
I cannot scan.
The document is not pulled into the
document feeder.
A document is jammed.
Scanning and copying
