Panasonic KX-FHD333BR, Service Manual

Page: 94 / 196

7.6.6.1. JOURNAL 2
Refer to JOURNAL 2 in PRINTOUT EXAMPLE(P.95).
Journal 2 displays the additional detailed information about the last 35 communications.
Descriptions:
(1) RCV. MODE
Indicates which receive mode the unit was in when the unit received a fax message.
This information is also displayed when the unit transmitted a fax message.
(2) SPEED
Indicates the speed of the communication. If multiple pages are transmitted or received, it indicates the last page’s communication
speed. If there is a communication error, "?" is displayed.
(3) RESOLUTION
Indicates the resolution of the communication. If multiple pages are transmitted or received, it indicates the last page’s resolution.
If there is a communication error, "?" is displayed.
(4) RCV-TRIG. (CNT.)
Indicates the trigger that causes the unit to switch to the fax receive mode. The available options are listed in JOURNAL 2 in
PRINTOUT EXAMPLE(P.95). The values in parentheses indicate how many times the trigger has been used. (For example, "0003"
means three times.)
No. Display Function
1 FAX MODE Means the unit received a fax message in the FAX mode.
2 MAN RCV Means the unit received a fax message by manual operation.
3 FRN RCV Means the unit received a fax message by friendly signal detection.
4 VOX Means the unit detected silence or no voice.
5 RMT DTMF Means the unit detected DTMF (Remote Fax activation code) entered remotely.
6 PAL DTMF Means the unit detected DTMF (Remote Fax activation code) entered by a parallel connected
telephone.
7 TURN-ON Means the unit started to receive after 10 rings. (Remote Turn On: Service Code #573)
8 TIME OUT Means the unit started to receive after Ring Time Out in the EXT-TAM or TEL/FAX mode.
9 IDENT Means the unit detected Ring Detection.
10 CNG OGM Means the unit detected the CNG while it was sending the Dummy Ring Back Tone in the
TEL/FAX mode.
OR
Means the unit detected the CNG while it was sending the OGM in the ANS/FAX mode.
11 CNG ICM Means the unit detected the CNG while it was recording the ICM in the ANS/FAX mode.
(5) ERROR
→ →
MEMORY
Indicates the reason why the unit received a fax message in memory.
If you look at No.11 in the JOURNAL 2 in PRINTOUT EXAMPLE(P.95), it shows the fax message was received in memory due to
"PAPER OUT" error.
NO RESPONSE DISAPPEARED ON JOURNAL
The "NO RESPONSE DISAPPEARED ON JOURNAL" displays the information about the last 10 communications terminated by
"No Response". (Some of the communications terminated by "No Response" were not displayed in the JOURNAL.)
When a fax transmission cannot be performed because the other party’s unit is set to the TEL mode, "No response" will be printed.
94
KX-FHD333BR