Panasonic KX-FHD333BR, Service Manual

Page: 45 / 196

· There is something wrong with the unit.
· The document was not fed into the unit properly.
Reinsert the document. If misfeeding occurs frequently,
clean the document feeder rollers and try again. (Refer
to DOCUMENT FEEDER (P.27).)
·
Attempted to transmit a document longer than 600 mm.
Press the [STOP] to remove the document. Divide the
document into two or more sheets and try again.
·
[Alternately, turn off service code #559 to enable
sending of documents longer than 600 mm] (Refer to
SERVICE FUNCTION TABLE (P.48).)
·
The memory (telephone numbers, parameters, etc.) has
been erased. Re-program.
[The backup lithium battery on the top of the digital
board may be low or dead, so check it.]
·
The recording paper is not installed or the unit has run
out of paper. Install paper and press [SET] to clear the
message.
·
The recording paper is not fed into the unit properly.
Reinstall paper and press [SET] to clear the message.
(Refer to INSTALLING THE RECORDING PAPER
(P.16).)
· The recording paper has jammed near the recording
paper entrance. Clear the jammed paper and press
[SET] to clear the message. Do not install folded or
heavily curled paper. (Refer to RECORDING PAPER
JAMS (P.25).)
·
The back cover is open. Close it.
· There is no space to store new entries in navigator
directory. Erase unnecessary entries.
·
The unit has a document in memory. See the other
displayed
message instructions to print out the
document.
·
The memory is full of received documents due to lack of
recording paper or a recording paper jam. Install paper
or clear the jammed paper. (Refer to RECORDING
PAPER JAMS (P.25).)
·
When performing memory transmission, the document
being stored exceeds the memory capacity of the unit.
Transmit the entire document manually.
·
The film is empty. Replace the film with a new one.
(Refer to INSTALLING THE INK FILM (P.15).)
· The ink film is slack. Tighten it and install again. (Refer
to RECORDING PAPER JAMS (P.25).)
·
The remaining film is low. Prepare a new film. (Refer to
INSTALLING THE INK FILM (P.15).)
· When making a copy, the document being stored
exceeds the memory capacity of the unit. Press [STOP]
to clear the message. Divide the document into
sections.
7 TROUBLESHOOTING GUIDE
7.1. USER RECOVERABLE ERRORS
If the unit detects a problem, one or more of the following messages will appear on the display.
The explanations given in the [ ] are for servicemen only.
45
KX-FHD333BR