12. Help
88
12 Help
Error Messages
12.1 Error messages –
Reports
If a problem occurs during fax transmission or
reception, one of the following messages will be
printed on the sending and journal reports (page
41).
COMMUNICATION ERROR
(Code: 40-42, 46-72, FF)
L
A transmission or reception error occurred.
Try again or check with the other party.
COMMUNICATION ERROR
(Code: 43, 44)
L
A line problem occurred. Connect the
telephone line cord to a different jack and try
again.
L
An overseas transmission error occurred. Try
using the overseas mode (feature #23 on
page 65).
DOCUMENT JAMMED
L
The document is jammed. Remove the
jammed document (page 100).
ERROR-NOT YOUR UNIT
(Code: 54, 59, 70)
L
A transmission or reception error occurred
because of a problem with the other party’s
fax machine. Check with the other party.
JUNK FAX PROH. REJECT
L
The fax was rejected by the junk fax
prohibitor feature (page 50).
MEMORY FULL
L
The memory is full of received documents
due to a lack of recording paper or a
recording paper jam. Install paper (page 18)
or clear the jammed paper (page 98).
NO DOCUMENT
L
The document was not fed into the unit
properly. Re-insert it and try again.
OTHER FAX NOT RESPONDING
L
The other party’s fax machine is busy or has
run out of recording paper. Try again.
L
The other party’s fax machine rings too many
times. Send the fax manually (page 40).
L
The other party’s machine is not a fax
machine. Check with the other party.
L
The number you dialled is not in service.
PRESSED THE STOP KEY
L {
STOP
}
was pressed, and fax transmission
or reception was cancelled.
OK
L
Fax transmission or reception was
successful.
12.2 Error messages –
Base unit display
If the unit detects a problem, one or more of the
following messages will appear on the display.
—————————————————————
BUSY
L
The cordless handset you tried to call is in
use.
L
The cordless handset you are calling is too
far from the base unit.
—————————————————————
CALL SERVICE
CALL SERVICE 2
L
There is something wrong with the unit.
Contact our service personnel.
—————————————————————
CHECK DOCUMENT
L
The document was not fed into the unit
properly. Re-insert the document. If
misfeeding occurs frequently, clean the
document feeder rollers (page 102) and try
again.
L
Attempted to send a document longer than
600 mm. Press
{
STOP
}
to remove the
document. Divide the document into two or
more sheets and try again.
—————————————————————
CHECK FILM
L
The ink film is empty. Replace the ink film
with a new one (page 17).
L
The ink film is not installed. Install it (page
15).
L
The ink film is slack or creased. Tighten it
(see step 5 on page 15).
—————————————————————
CHECK MEMORY
L
Memory (telephone numbers, parameters,
etc.) has been erased. Re-program.
FC243FX-PFQX2104ZA_en.book Page 88 Tuesday, November 2, 2004 2:10 PM
Summary of Contents for KX-FC243FX
Page 112: ...110 ...
Page 113: ...111 ...
