20
Display Panel Instructions
Others menu
No.
Item
LCD
Content
Page
01
Checking the version
Version
Displays the firmware version of the mechanical
control, pre-imprinter or post-imprinter.
If an optional imprinter is not installed, the imprinter
version will not be displayed.
30
02
Setting the buzzer
Buzzer
Selects whether the buzzer is turned on or off.
If selection is in the “ON” position:
When pressing a key, one short beep will be heard.
When there is an error, 5 short beep will be heard.
When scanning is completed correctly, one long beep
will be heard.
03
Setting the SCSI ID
SCSI ID
Sets the SCSI ID No.
04
Setting the terminator
Terminator
Set “Enable” or “Disable”.
“Enable”: If last device on chain
“Disable”: If between devices
05
Setting the transfer
rate
Transfer Rate
•
Changes the maximum value of the synchronous
transfer rate of the SCSI interface.
•
Lower the synchronous transfer rate to 10 Mbytes/
sec. if the computer has failed to recognize the
scanner or the scanner fails to operate properly.
06
Checking the roller
cleaning warning
Clean Roller
The alarm tells you it is time to check roller.
If it is near 100%, clean the roller. See “Cleaning the
Unit” on
page 44
.
31
Clearing the roller
cleaning warning
Clean Roller
Clear the “Clean Roller Warning
≤≤
%” display.
07
Checking the roller
modules replacement
warning
Replace Roll.
The alarm tells you the roller needs to be changed.
If it is near 100%, replace the paper feed roller module
and retard roller module. See “Replacing Consumable”
on
page 52
.
Clearing the roller
modules replacement
warning
Replace Roll.
Clear the “Replace Roll. Warning
≤≤
%” display.
08
Setting the product ID
Product ID
Selects the product ID. The product ID setting depends
on the host computer scanner application you are
using.
Allows scanner to emulate other Panasonic scanner.
32
09
Setting the sleep
mode
Sleep Mode
Sets the time until sleep mode turns ON.