Panasonic GT series, Manual

Page: 30 / 136

1-18
Bit/Word Device No. Memo
Word
Device
Input Relay X000000-X001FF Specify address expression every 0
Output Relay Y000000-Y001FF0 Specify address expression every 0
Internal Relay M000000-M032752
Specify address expression every 16
multiples
Latch relay L000000-L032752
Annunciator F000000-F032752
Edge relay V000000-V032752
Link Relay B000000-B007FF0 Specify address expression every 10
Special relay SM000000-SM002032
Link special relay SB000000-SB0007F0
Step relay S000000-S008176
Direct access input DX000000-DX001FFF
Direct access output DY000000-DY001FFF
Timer(current) TN000000-TN023087
Retentive timer(Current
value)
SN000000-SN023087
Counter(current) CN000000-CN023087
Data Register D000000-D025983
Link Register W000000-W00657F
Link special register SW000000-SW0007FF
Index register Z0-Z15
File Register(for block
number)
R000000-R032767
File register(for
sequential number)
ZR000000-ZR1042431
Special register SD000000-SD002047
Note:
-
The maximum value that can be set with the GT is described.
-
The range of usable addresses differs depending on the model. For details, please consult the manual
for the PLC you will use.
-
When you use a serial communication module, you will set some parameters (Slot No., Module type,
I/O points and Start address etc). Input and output relay from the start address for set points can’t be
used.
-
Although "Mitsubishi MELSEC-A (Computer Link) Series" can be used, the address range is the same
as the one for "Mitsubishi MELSEC-A (Computer Link) Series".