18
q
Camera title setting [CAMERA ID]
This item specifies the camera title. The camera title that indicates the camera location and other information about the camera
is created with alphanumerics, symbols and displayed on the screen. The camera title is named with up to 16 characters.
Follow the procedure below to specify the camera title.
Top screen of SETUP menu
Title creation screen
Display positioning screen
** SET UP ** P1
CAMERA ID *OFF
ELC *OFF
SHUTTER OFF
GAIN OFF
SENS UP OFF
BINNING OFF
OUTPUT SEL RGB
HDMI OUTPUT YPbPr(422)
END
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
0123456789
().,'":;&#!?=
+-*/%$ÄÜÖÆÑÅ
←
→
SPACE
*POSI RET END RESET
................
FLOOR 1
Step 1
Set “CAMERA ID” to “ON” and press the [SEL] button.
The title creation screen appears.
→
Important:
When “CAMERA ID” is set to “OFF”, the camera title
•
does not appear even after setting the camera title.
Note:
Even when “CAMERA ID” is set to “OFF”, pressing the
•
[SEL] button allows the title creation screen to appear.
Step 2
Move the cursor to the target character by pressing the [
g
],
[
h
], [
e
] and [
f
] buttons, and press the [SEL] button.
The entered characters are displayed in the editing area.
→
<Character entry>
To revise a character, move the cursor to “
•
←
” or “
→
”
and press the [SEL] button. Move the cursor to the
character to be revised in the entry range and reenter a
correct character.
To enter a blank, move the cursor to “SPACE” and press
•
the [SEL] button.
To delete all the entered characters, move the cursor to
•
“RESET” and press the [SEL] button.
Step 3
Move the cursor to “POSI” and press the [SEL] button after
title entry.
The display positioning screen appears and the entered
→
camera title blinks.
Step 4
Use the [
g
], [
h
], [
e
] and [
f
] buttons to decide the title
position, and hold down the [FREEZE MENU ] button for 2
seconds or more.
The display position is determined and the title creation
→
screen appears again.
Editing area