Error Message
Follow the instructions below when an error message appears. If the problem persists or if the error message is not shown here, contact Panasonic Tech-
nical Support.
Error Message
Solution
Bad System
CMOS
An error has occurred in the memory of system settings. This occurs when the memory content is changed by an unexpected pro-
gram operation, etc.
Start the Setup Utility and return the settings to the default values, and then change the settings as necessary.
If the problem persists, the internal clock battery may need to be replaced. Contact Panasonic Technical Support.
System CMOS
Checksum Error
Invalid Year. Sys-
tem date restored
to 01/01/20XX
The date and time settings are not correct.
Start the Setup Utility and set the correct date and time.
If the problem persists, the internal clock battery may need to be replaced. Contact Panasonic Technical Support.
Press F2 for
Setup
Write down the error details and start the Setup Utility.
Change the settings if necessary.
Warming up the
system (up to 30
minutes)
The computer is warming up before start up. Wait for the computer to start up (takes up to 30 minutes). If, “Cannot warm up the
system” is displayed, the computer failed to warm up and does not start. In this case, turn off the computer, leave it in an envir-
onment of 5 °C {41 °F} or higher temperature for about an hour, and then turn on the power once more.
Remove disks or
other media.
Press any key to
restart
If a device is connected to the USB port, disconnect the device, or set [USB Port] to [Disabled] in the [Advanced] menu of
the Setup Utility.
If the problem persists after removing the disk, it may be a flash memory failure. Contact Panasonic Technical Support.
Please use the
recommended
AC adaptor
Use the specified AC adaptor.
-
128
-