Live
Adaptor
mm (inches)
CAUTION:
Mount junction box cover carefully so that lead wires are not
pinched
INSTALLATION
II
(WOODEN HEADER)
CONTINUED
INSTALLATION
II
(WOODEN HEADER)
CONTINUED
2. Install header between ceiling joists using nails or screws.
3. Install the ventilating fan and secure with screws.(Fig.13 and Fig.14)
4. Insert the circular duct to the adaptor.
Remove the junction box cover and secure conduit to junction
box knockout hole (7/8 inch) (Fig.14 )
5. Refer to wiring diagram.
Using wire nuts,connect house power wires to ventilating fan wires:
black to black; white to white; green to green.
Replace the junction box cover.
Long screws
Junction box cover
Ventilating fan
Ceiling joist
Header
Ceiling joist
Wiring diagram
Adaptor
6. Finish ceiling work. Ceiling hole should be aligned with
edge of the flange. (Fig.15 )
7. Mount grille to fan body. (Fig.11, page 8.)
Circular duct
Fig.13
Fig.14
Ceiling
Flange
Fig.15
CAUTION:
To install the ventilating fan, follow the procedures described in lnstallation II. Take the following precautions before
installation.
,
1. Installation in existing construction.
Installing the ventilating fan in an existing building requires an accessible area (attic or crawl space) above the planned
installation location or existing ducting and wiring.
Check area above planned installation location to be sure that:
1. Duct work can be installed and that area is sufficient for proper ventilation.
2. Wiring can be run to planned location.
3. No wiring or other obstructions will interfere with installation.
Inspect duct work and wiring before proceeding with installation.
Plan suitable location for ventilating fan.(next to ceiling joist)
INSTALLATION
III
(IN EXISTING CONSTRUCTION)
Power Supply
AC120V 60Hz
Earth
Motor
Thermal Cutoff
Black
Black
Black
Red
Capacitor
White
Green
M.C.
A.C.
White
White
Green
Neutral
