4
Parts identification
Operating conditions
It would be effective if placed
here!
Front
Front
panel
Power plug
Handle
(Right and left)
Humidity sensor
Air inlet
(both sides)
Air inlet
(Front)
Power
cord
Control panel
Dirt sensor
Air outlet
(nanoe™ emission outlet)
Tray
Tray handle
Floater (inside)
Humidifying
filter
Filter frame
Water-level
window
Ion sterilization unit
(anti-fungus agent
containing) (inside)
■
Do not put the product in the following places:
●
Where the product will be exposed to direct
sunlight or direct blowing/heat of air conditioner.
(Otherwise, deformation, deterioration,
discoloration or malfunction may be caused.)
●
Near the window or where the humidity sensor
area is blocked.
●
Where the wind from air outlet is directly applied to
furniture or wall. (Stains may be caused.)
●
Near a TV set or radio. (Otherwise, distortion or
noises may be caused.)
→
Keep 1 m or more away from such devices. If
the power plug is inserted into the same outlet
as that of these devices, distortion or noises
may be caused. In this case, insert the power
plug into another outlet.
■
Do not place any objects on the product.
(Otherwise, malfunction or failure may be caused.)
●
Do not place magnets, metallic objects or similar objects on the product. (Otherwise the built-in magnet detects
turnover causing the check indicator to light up, which will stop operation of the product.)
■
When there is a risk of freeze, please empty the tray.
(If the product operates with water frozen, failure may
be caused.)
■
When using the product in the same area for extended periods of time
Using the product continuously in one location may cause the wall, floor or other areas around the product to
become dirty due to the air sucked in at the bottom of the product.
We recommend to move the product to a different location occasionally or clean the wall, floor or other areas
regularly.
■
Place it low on the floor as a countermeasure
against pollen.
Since pollen and dusts are likely to float in the air
near the floor, we recommend you to put the
product on the flat floor in the room.
■
To circulate the air efficiently in the room.
To prevent the air inlet or the air outlet from
being blocked, install the product with its right,
left and the top about 30 cm or more away from
walls or furniture, curtains etc. To ensure efficient
use of the product, keep its back at least 1 cm
away from the wall.
Back
VXL40M_EN_ARA.indd 4
9/30/2015 2:57:57 PM
