ENGLISH -
7
Installation
After checking the height, width and structure of the installation location while referring to the “Dimensional
relationship diagram” (pages 5-6) and “Dimensional relationship” in the Appendix, determine the appropriate posi-
tions for setting up the screen and installing the projector.
Setting up the screen
Set up the screen according to the specified method in a position which takes into account the projection distance
and angle and the type of screen being used.
Screws tightening torques
M4………1.25 ± 0.2 N • m
z
When tightening the screws, use a torque screwdriver or a hexagonal torque wrench to tighten the screws to
the specified tightening torques. Do not use electric screwdrivers or impact screwdrivers.
Attaching the projector drop-prevention kit
Install the wire rope to the projector (sold separately).
<
For PT-VZ585N, PT-VZ575N, PT-VZ580, PT-VZ570, PT-VW545N, PT-VW535N, PT-VW540, PT-VW530, PT-VX615N,
PT-VX605N, PT-VX610, PT-VX600, PT-VX61K, PT-VX60, PT-VX51K, PT-VX50, PT-VMZ60, PT-VMZ50, PT-VMZ40,
PT-VMW60, PT-VMW50, PT-VMZ601K, PT-VMZ501K, PT-VMZ401K, PT-VMW601K, PT-VMW501K / PT-VGZ601K>
Adjustable
feet lock latch
Adjustable feet
The illustration is an example when it is attached to
PT-VZ585N.
1 Place the projector upside down on top of a soft
cloth.
2
Retract the adjustable feet.
z
Press the adjustable feet lock latch and release
them at shortest length of the adjustable feet.
Or rotate the adjustable feet in clockwise to
retract them.
A
A
Wire rope
Wire rope
Screw, captive
washer
(M4
x
12)
Screw, captive
washer
3 As illustrated on the left, secure the one end
(round crimping terminal) of the supplied wire
rope to the A on the projector by using the sup-
plied captive washer screw (M4 x 12).
Attention
z
Be sure to use the supplied wire rope.
Note
z
Use the supplied flat washer while installing the
wire rope to the ceiling.
z
The position of A may vary with the model. Check
the position and number of the screw hole in “Ceiling
mount hole size” indicated on the bottom of the
projector, try placing the bracket on the projector
bottom, and use the screw hole unoccupied.
