Panasonic ET-JPF100BU, Operating Instructions Manual

Page: 2 / 16

2 - ENGLISH
Read this first!
WARNING
Do not do anything that might damage the power cord or the power plug.
If the power cord is used while damaged, electric shocks, short-circuits or fire will result.
z
Do not damage the power cord, make any modifications to it, place it near any hot objects, bend it
excessively, twist it, pull it, place heavy objects on top of it or wrap it into a bundle.
Ask your dealer to carry out any repairs to the power cord that might be necessary.
Do not use anything other than the provided power cord.
Failure to observe this will result in electric shocks or fire. Please note that if you do not use the provided power
cord to ground the device on the side of the outlet, this may result in electric shocks.
Completely insert the power plug into the wall outlet and the power connector into the projector
terminal.
If the plug is not inserted correctly, electric shocks or overheating will result.
z
Do not use plugs which are damaged or wall outlets which are coming loose from the wall.
Do not handle the power plug and power connector with wet hands.
Failure to observe this will result in electric shocks.
Do not use other than a specified projector.
Do not install a projector in a way other than specified.
Doing so may cause a fall accident, fire, or electric shock.
Do not install the product in a place unable to withstand the weight or somewhere that is unsteady or
tilted.
Doing so may cause a failure or injury due to dropping, falling, etc.
Do not install the product near an entrance to a room or in a corridor.
Bumping into the product or tripping on the power cord may cause a fire, electric shock, or injury.
Do not set up the projector in humid or dusty places or in places where the projector may come into
contact with oily smoke or steam.
Using the projector under such conditions will result in fire, electric shocks.
Do not place the projector on soft materials such as carpets or sponge mats.
Doing so will cause the projector to overheat, which can cause burns, fire or damage to the projector.
Do not block projector heat dissipation.
Heat accumulating inside the projector may cause a fire.
z
Install the product so that the intake and exhaust of the projector will not be blocked.
Do not modify the floor stand.
Doing so may cause a malfunction due to falling, etc. or an electric shock or injury.
Do not use the supplied power cord with equipment other than a specified projector.
Using the supplied power cord with equipment other than a specified projector may cause electric shock or fire
due to a short or heat generation.
Do not allow children to reach the supplied screws.
Accidentally swallowing them can cause physical harm.
z
If swallowed, seek medical advice immediately.
CAUTION
When disconnecting the power cord, be sure to hold the power plug and power connector.
If the power cord itself is pulled, the lead will become damaged, and fire, short-circuits or serious electric
shocks will result.
Do not place the projector in extremely hot locations.
Doing so will cause the outer casing or internal components of the projector to deteriorate, or result in fire.
z
Take particular care in locations exposed to direct sunlight or near heaters.