6
English
Safety precautions
Make sure to follow these instructions.
To prevent accidents, injuries or damage to property, please
follow the instructions below.
■
The following chart indicates the degree of damage
caused by improper operation.
CAUTION
Indicates potential hazard that could
result in minor injury or property damage.
CAUTION
►
Protecting the skin
•
Do not press the blade strongly against the skin.
•
Do not use the appliance for any purpose other than
trimming beard, hair and body hair.
•
Do not directly apply the blades on ears or rough skin
(such as swellings, injuries or blemishes).
‑ Doing so may cause injury to ears or uneven skin.
•
Check the blades are not damaged or deformed before use.
‑ Failure to do so may cause injury to the skin.
Important information
• Apply the lubrication oil to the blade before and after each
use. (See page 10.)
Failure to apply the lubrication oil may cause the following
problems.
‑ The appliance has become blunt.
‑ Shorter operating time.
‑ Louder sound.
Parts identification (Fig. 1)
A
Head
1
Water inlet
2
Trimming height
indication mark
3
Dial (Height adjustment
control)
4
Water outlet
5
Blade
Accessories
B
Comb attachment [A]
(1 mm to 10 mm)
C
Comb attachment [B]
(11 mm to 20 mm)
D
Comb attachment [C]
(21 mm to 30 mm)
E
Comb attachment for
body hair [D]
How to use
• Clean the appliance after use.
1
Mount the head to the main body until it clicks.
2
Mount the desired comb attachment and adjust the
trimming height as needed.
▪
It can also be used without the comb attachment.
(Trimming height: approx. 0.5 mm)
▪
Do not use the comb attachment on wet hair. Wet hair
might clump or stick to the skin, becoming hard to trim.
▪
Setting of 10.5 mm and 20.5 mm is unavailable.
▪
The trimming height of the comb attachment for body hair
cannot be adjusted. This comb attachment trims to a
length of approximately 1.5 mm.
3
Turn on the power.
Note
• The use time after a full charge is as follows.
ER‑CBL1: 70 minutes
ER‑CBN1: 40 minutes
(Based on dry using at 20 °C – 30 °C)
The operating time may differ depending on the frequency of
use and the operating method.
