Panasonic DP-MB251CX, Operating Instructions Manual

Page: 79 / 152

Feature Code Selection
ECM selection #413 To set the Error Correction Mode (ECM). This feature is available when the
sending / receiving fax machines are ECM compatible. When
“
ON
” is selected,
fax transmission / reception will be carried out so that the errors do not occur.
M 0 N “
OFF
”
M 1 N “
ON
” (default)
Connecting tone #416 If you often have trouble when sending faxes, this feature allows you to hear
connecting tones: fax tone, ring back tone and busy tone. You can use these tones
to confirm the status of the other party’s machine.
M 0 N “
OFF
”
M 1 N “
ON
” (default)
Note:
R If the ring back tone continues, the other party’s machine may not be a fax
machine or may have run out of paper. Check with the other party.
R The connecting tone cannot be adjusted individually.
Maximum fax
speed #418 To set the maximum fax speed. The fax speed may be lower than the selected
speed depending on your line.
M 1 N “
14.4kbps
”
M 2 N “
33.6kbps
” (default)
Quick scan mode #419 To enable quick scan mode. When “
ALWAYS
” is selected, the unit will scan the
document and store it into memory first, then the unit will start sending the
documents.
M 0 N “
OFF
” (default)
M 1 N “
ALWAYS
”
Confirming the
destination #420 To confirm the destination before sending a fax. When “
ON
” is selected, you can
send a fax after confirming the destination. When the displayed destination is
correct, press
MxN to send the fax.
M 0 N “
OFF
” (default)
M 1 N “
ON
”
Dial keypad entry
restriction #421 If you want to restrict dialling fax numbers manually using the dial keypad (to avoid
misdialling, for example), activate this feature.
M 0 N “
OFF
” (default)
M 1 N “
ON
”
Note:
R If you select “
ON
” , you cannot make redial calls to fax numbers entered using
the dial keypad.
R If you select “
ON
” , the fax number re-entry setting (feature #422 on
page 79) will be deactivated.
Fax number
re-entry #422 When “
ON
” is selected, if you dial a fax number manually using the dial keypad,
you have to re-enter the number and press MxN . When the 2nd entry number
matches the 1st entry number, you can send the fax.
M 0 N “
OFF
” (default)
M 1 N “
ON
”
Confirming the
next document #424 When “
ON
” is selected, after the document is scanned using the automatic
document feeder during fax memory transmission, the message shows to confirm
the next document. Insert the next document and press
M SET N . A MxN
M 0 N “
OFF
” (default)
M 1 N “
ON
”
Direct SMTP #425 For registering an email address when “
ON
” is selected, you can set the direct
SMTP for the email address.
M 0 N “
OFF
” (default)
M 1 N “
ON
”
79
12. Programmable Features