33
9.1.3.
Top Case
1. Remove the 3 Screws .
2. Slide Top Case rearward and open the both ends at rear
side of the Top Case a little and lift the Top Case in the
direction of the arrows.
9.1.4.
Front Panel Ass'y
9.1.4.1.
Tray Top
1. Put deck so that bottom can be seen.
2. Insert the Paper clip, etc. into the hole on the bottom of
BD Drive and slide the Paper clips, etc. in the direction of
the arrow to eject tray slightly.
3. Remove the tray top from the tray section.
9.1.4.2.
Front Panel
1. Remove the connector.
2. Unlock 6 tabs (A)-(F) turn. Pull with the Front Panel in the
direction of your side.
9.1.4.3.
Power SW P.C.B.
1. Remove the Screw.
2. Remove the Power SW P.C.B..
9.1.4.4.
Application of the Lubricant to
Door Ass'y
1. Lubrication points on door ass'y are shown in the figure
as below.
2. Since the replaced parts are not lubricated, please apply
lubricant to the specified points (RFKXGUD24).
3. Use Cotton Swab to spread thinly.
Summary of Contents for DMP-BDT220GA
