133
VQT1Z45
Others
[MEMORY CARD ERROR
FORMAT THIS CARD?]
•
This card has a format which is not recognized by the camera.
>
Format the card again with the camera after saving necessary data on a PC etc. (P32)
[PLEASE TURN CAMERA OFF AND THEN ON AGAIN]/[SYSTEM ERROR]
•
This message will be displayed if the lens did not operate properly.
>
Turn the camera off and on. If the message persists, contact the dealer or your nearest
Service Center.
[MEMORY CARD PARAMETER ERROR]
>
Use a card compatible with this unit. (P21)
•
You can only use an SDHC Memory Card if using cards with 4 GB or more capacity.
[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
•
An error has occurred accessing the card.
>
Insert the card again.
>
Insert a different card.
[READ ERROR/WRITE ERROR
PLEASE CHECK THE CARD]
•
It has failed to read or write data.
>
Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
•
The card may be broken.
>
Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
•
It is recommended to use a card with SD Speed Class
¢
with “Class 6” or higher when
recording motion pictures.
¢
SD speed class is the speed standard regarding continuous writing.
•
When you set the picture quality to [
], [
] or [
], we recommend using a high-speed
card with “10MB/s” or greater displayed on the package.
•
In the event that it stops even after using a “10MB/s” card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P32).
•
Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording
may stop in the middle.
[A FOLDER CANNOT BE CREATED]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
(P121)
>
Format the card after saving necessary data on a PC etc. (P32) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P29)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
•
The AV cable is connected to the camera.
>
Press [MENU/SET] if you want to delete this message at once.
>
Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P30)
•
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P118,
122)
VQT1Z45~_eng.book 133 ページ ２００９年１月２８日 水曜日 午後９時３０分
