119
VQT1Z45
Connecting to other equipment
Preparations:
Turn on the camera and the PC.
Remove the card before using the pictures in the built-in memory.
A
USB connection cable (supplied)
•
Check the directions of the connectors, and plug them straight in or unplug them straight out.
(Otherwise the connectors may be bent out of shape which will cause trouble.)
B
Align the marks, and insert.
•
Use a battery with sufficient battery power or the AC adaptor (DMW-AC5PP; optional). When
using the AC adaptor (DMW-AC5PP; optional), use the multi conversion adaptor (DMW-MCA1;
optional). If the remaining battery power becomes low while the camera and the PC are
communicating, the status indicator blinks and the alarm beeps.
Refer to
“
Disconnecting the USB connection cable safely
”
(P120) before disconnecting the
USB connection cable. Otherwise, data may be destroyed.
Connect the camera to a PC via the USB connection cable
A
(supplied).
•
Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
Acquiring of still pictures and [MOTION JPEG] motion pictures
(other than [AVCHD Lite] motion pictures)
Press
3
/
4
to select [PC], and then press
[MENU/SET].
•
If [USB MODE] (P30) is set to [PC] in the [SETUP] menu in
advance, the camera will be automatically connected to the PC
without displaying the [USB MODE] selection screen. Since there
is no need to set this each time you connect to the PC, it is
convenient.
•
When the camera has been connected to the PC with
[USB MODE] set to [PictBridge(PTP)], a message may appear
on the PC’s screen. Select [Cancel] to close the screen, and
disconnect the camera from the PC. Then set [USB MODE] to
[PC] again.
USB MODE
PLEASE SELECT
THE USB MODE
PictBridge(PTP)
PC
SELECT
SET
VQT1Z45~_eng.book 119 ページ ２００９年１月２８日 水曜日 午後９時３０分
