
T
ro
uble
s
ho
oting
VQT2J58
90
Messages on the unit’s display
Troubl
eshooti
ng
The following messages or service numbers appear
on the unit’s display when something unusual is
detected during startup and use.
DVD
(“
∑
” stands for a number.)
¾
The remote control and main unit are using
different codes. Change the code on the remote
control.
GUIDE
¾
TV Guide data is being downloaded. (
>
19)
FINISH
¾
The software (firmware) update is complete.
(
>
87)
HARD ERR
¾
If there is no change after turning the unit on and
off, consult the dealer where the unit was
purchased.
NoERAS
¾
You cannot delete items on this disc.
The disc may be damaged. Use a new disc.
NoREAD
¾
The disc is dirty or badly scratched. The unit
cannot record, play, or edit. (
>
103)
¾
This message may appear when the lens cleaner
has finished cleaning.
Press [
<
OPEN/CLOSE] on the main unit to eject
the disc. (
>
14)
NoWRIT
¾
You cannot write to this disc.
The disc may be damaged. Use a new disc.
PLEASE WAIT
¾
Displayed when the unit is started and turned off.
¾
There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. This process
restores the unit to normal operation. The unit is
not broken. Wait until the message disappears.
PROG FULL
¾
There are already 32 timer programmes. Delete
unnecessary timer programmes. (
>
29)
REMOVE
¾
The USB device is drawing too much power.
Remove the USB device.
START
¾
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. (
>
87)
SW-DL
¾
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (
>
87)
UNSUPPORT
¾
You have inserted a disc the unit cannot play or
record on. (
>
98)
You tried to operate with a non-compatible USB memory.
UPD
/
(“
∑
” stands for a number.)
¾
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. (
>
87)
U59
¾
The unit is hot.
The unit switches to standby for safety reasons. Wait for
about 30 minutes until the message disappears.
Select a position with good ventilation when
installing the unit. Do not block the cooling fan on
the rear of the unit.
1
Press and hold [OK] and the
indicated number button at
the same time for more than
5 seconds. (
>
85)
2
Press and hold [OK] for more
than 5 seconds.
DMRXW380EB-VQT2J58_eng.book 90 ページ 2010年4月8日 木曜日 午後3時54分
Summary of Contents for DIGA DMR-XW380
Page 122: ...Reference VQT2J58 122 ...