![background image](http://html.mh-extra.com/html/panasonic/dbs-40/dbs-40_manual_264468053.webp)
Chapter
4.
Trunks and Lines
Section
2. Install the loop-start trunk in a trunk slot.
3.
Use a standard
cable to connect the trunks from the MDF to the
main trunk connector
Installation with Caller ID
1. Remove the cover from the L-TRK card (VB-435
This cover should
be set aside since it cannot be reinstalled with a Caller ID Board installed.
2.
Cut strap on the L-TRK card as shown in Figure 4-2.
3.
Set switches SW1 through SW8 on the
card (VB-43511A) to
OFF.
A
IMPORTANT: When caller ID is used, you must correctly set the switches to prevent possible
damage to the
L-TRK
card.
4. Attach the Caller ID card to the L-TRK card.
Figure 4-3. Attaching Caller ID Card to the
Card
ID Board
L-TRK Card
5. Install the L-TRK card in a trunk slot.
6. Use a standard
cable to connect the trunks from the MDF to the
main trunk connector CN 1.
4-8
Manual issued
Summary of Contents for DBS 40
